Bring us the fixture you want, or we can supply it. Either way works.
We pressure test every install before we leave.
Old supply lines and shut-offs often fail when disturbed. We will tell you up front if yours need to be replaced too.
Resource Guide
Fixture Installation Guide
A straight-talking guide from the owner who installs every job. Sink, Faucet & Fixture Installation in San Antonio.
Installed by Hector · 24-48 Hr Turnaround · Se Habla Español
- Licensed Contractor
- Onyx Certified
- Home Depot Installer
- Lifetime Warranty
- 14+ Yrs Experience
- Se Habla Español
- Veteran & Senior Discounts
Back to Sink, Faucet & Fixture Installation
1. Cost & Pricing Overview
Typical price range
$150–$600 per fixture installed (most jobs)
What affects the cost
- Fixture type (kitchen faucet, bath faucet, shower valve, sink)
- Whether supply lines and shut-offs need replacement
- Existing rough-in compatibility
- Single-hole vs. widespread vs. wall-mount
- Granite or stone counter sealing
When a quote is required
Bid pricing per install — no hourly billing. We tell you up front if your shut-offs need replacement before we open anything up.
Want a real number for your home? Request a free estimate.
2. How the Service Works
Here's exactly what to expect from start to finish.
- 1Confirm fixture and supply compatibility.
- 2Remove existing fixture.
- 3Install new fixture, tie in supplies and drain, test.
3. Common Problems, Signs & Symptoms
If you're seeing any of these, it's probably time to call.
Faucet drips even when fully closed
Worn cartridge or seat. Sometimes a $40 cartridge replacement, sometimes a full faucet swap is smarter long-term.
Handle doesn't hold temperature anymore
Shower valve cartridges wear out. The temperature drift gets worse until it fails completely.
Shut-off valve under the sink doesn't work
Old quarter-turn valves seize. When they do, you can't isolate the fixture for repairs — the whole house water has to be shut down.
Sink basin is cracked or corroded
Once a sink starts cracking, it gets worse. Replacement is the only real fix.
DIY fixture install started leaking
Most DIY leaks come from over-tightened connections that crack a fitting, or under-tightened ones that don't seal. We'll fix it right.
4. Frequently Asked Questions
Bottom line
It is amazing how often a 'simple' fixture swap turns into a leak two weeks later. Done right means done once. Free estimates within 30 miles of San Antonio.
Related guides in Plumber
Questions about sink, faucet & fixture installation?
Call Hector. He'll give it to you straight.